Pc Hardware Diagnostics Uefi Test Fails

The HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that provides diagnostic tests to run across if your PC hardware is working properly, by isolating hardware failures. After seeing a Blue Screen on my Windows 11/x PC recently, on reboot, I saw the Boot Device Non Found error with an option to click on F2 for Organisation Diagnostics. In this postal service, we will learn a chip near this free tool from HP for Windows 11/10.

HP PC Hardware Diagnostics UEFI on Windows 10

HP PC Hardware Diagnostics UEFI

While it is evident, do note that the tool runs outside the Windows 10 OS. It makes it easy to isolate hardware failures from issues caused either by the Os or any application. It checks for problems in Retentiveness or RAM and Hard Bulldoze. If the test fails, it will show a 24-Digit failure ID. Y'all will need to connect with HP's customer support with it.

HP PC Hardware Diagnostics comes in two versions — Windows version and UEFI versions. The UEFI version should be used when y'all cannot kicking into Windows. In this post, we will talk near the UEFI version, how it works, and how you can install it on EFI Segmentation or USB drive.

  • How to run the UEFI Tests
  • UEFI Fast and All-encompassing test
  • How to install HP PC Hardware Diagnostics UEFI
  • HP PC Hardware Diagnostics for Windows

How to run the HP PC Hardware Diagnostics UEFI

If the computer has the UEFI diagnostic tool installed on the computer, it can exist launched using the F2 key. Still, if the tool is not installed, you can create a USB. Lets offset have a expect at how you lot can use it when it is available on the computer.

Completely ability downward the computer ( hold the power push button for at least five seconds to plough off the computer), and then turn it on. Immediately press the F2 key repeatedly until the UEFI carte du jour opens.UEFI menu will give a couple of diagnostic tools, select the one y'all desire, and follow the on-screen instructions.

HP PC Hardware Diagnostics UEFI on Windows 10

In both memory and hard disk drive test, the tool will run the Fast Test to identify hardware issues chop-chop. If at that place is no error detected, simply the computer has hardware problems, then it volition run the Extensive Test. The later tin can take hours to complete the test.

UEFI Fast and Extensive test

The screen displays the progress bar on a Control Prompt screen along with the estimated time left to complete the test. You lot can always press ESC to cancel the test, simply do so only when you have no other pick.

HP PC Hardware Diagnostics UEFI on Windows 10

If the tool doesn't observe any mistake, and then you should encounter "Passed" message, else information technology will kick start the all-encompassing examination.

Memory Quick Test

The process is the aforementioned for Hard disk drive bank check. In our instance, while the Smart Check passed, the Short DTS bank check failed.

It and then displayed Failure ID, Product ID, and bulldoze number related to it.

HP PC Hardware Diagnostics.

If you receive the same, yous can get to the HP customer support website and enter the code, production ID and select your country to resolve the problem further.

How to install HP PC Hardware Diagnostics UEFI

It is possible to run the UEFI diagnostics tool from a USB bulldoze or install it on the UEFI partitioning on your reckoner. In case yous cannot admission Windows, we advise using another computer to create the USB drive, and kick the computer to access the tool. However, make sure to disable Secure boot before doing that. HP says that y'all tin use it on whatsoever HP estimator where it'south non preinstalled.

Not only you tin use this tool in case of a hardware effect, but if your computer is locked, you can utilise it to recover the reckoner.

run the UEFI diagnostics tool from a USB drive

  • Become to the HP Hardware Diagnostics website and download HP Diagnostics UEFI.
  • Locate the binder and run the EXE file.
  • Follow the installation wizard, accept the terms of the license agreement, and click Next.
  • Finally, you will accept to select between the installation location for the Hardware Diagnostics programme, then click Side by side
    • To download onto the calculator to test, choose UEFI Partition on Difficult Drive
    • To download to a USB drive, select USB Flash Bulldoze
  • Click Install, and then click Yes to create the HP_TOOLS sectionalisation
  • Wait while the software installs. Click End to shut the sorcerer

To run the tool from the USB drive, follow these steps:

Hardware Diagnostics program,

  • Insert the USB device, plough on the computer, and press the Esc key repeatedly until the Startup menu displays.

  • Then pressF2 to selectOrganisation Diagnostics and the preferred language from the listing.

  • It volition launch the PP PC Hardware Diagnostics habitation page opens, showing the version number and USBHardware Diagnostics program UEFI

  • Y'all can now choose to run

    • Symptom tests
    • System tests
    • Component tests
  • Y'all also get admission to Test logs, alter language, or go out.

HP PC Hardware Diagnostics for Windows

If you can access your computer but have a hardware failure for audio, video, and other input devices, yous tin can install the Windows version. They likewise have an app in the Microsoft Store. Similar to the UEFI tool, it offers Symptom, system, and component tests.

HP Diagnostics Windows Software

HP offers some incredible tools to assist consumers troubleshoot their computer for whatsoever hardware effect. Yous volition need a scrap of technical knowledge to run it, and if you discover it tough, you tin also utilize  HP Support Banana, which offers 1-click fixes, guided troubleshooting, and diagnostics.

HP PC Hardware Diagnostics UEFI failed

If a component fails a test, practise the following:

  1. Click Troubleshoot.
  2. Follow the on-screen instructions to resolve the trouble
  3. If the trouble is not resolved, Skillful!
  4. If the problem is not resolved, click Yeah to contact HP Client Support.
  5. Use the failure ID (24-digit lawmaking) and product ID when yous contact HP Customer Support.
  6. Click Next to go to the HP Customer Support website.

We hope you were able to run HP PC Hardware Diagnostics UEFI when in need or install information technology to troubleshoot hardware issues on the computer.

TIP: You can use HP Support Banana to update drivers and firmware.

0 Response to "Pc Hardware Diagnostics Uefi Test Fails"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel